![]() Another raid controller that is usually used for cheaper builds is software based and that might be the cause for your troubles. One creates well known /dev/cciss/c0d0 devices and is well supported under Linux. With that information, you could lookup whether the server is certified for the upstream product from Red Hat.Īlso with the server type you could find out, what raid controller is used and what driver might be needed.Īs far as I remember, there are different Proliant 360 raid controllers used. HP servers get updated from time to time and it is important to state the generation of the server. ![]() I tried switching the controller to AHCI which I read on some HP Knowledgebase, but that didn't seem to have an effect. Slots 3-5 are a RAID 5 for data, and slot 6 is a single drive for logs. The system has six physical SSDs split into three logical drives, slots 1 and 2 are a RAID 1 for the OS. I haven't had any time to do research on the issue myself, I just wanted to drop SF a line to see if anyone else had noticed a similar issue. The servers are Generation 8, and the have the HP Dynamic Smart Array B320i RAID controller. ![]() These were dropped in my lap and I was told to 'make it work'. ![]() I've used CentOS on dozens of servers before and never really had an issue, but most of those were custom ordered to be compatible with CentOS. Upon reboot after installation, the server reports that it is attempting to boot from drive C: and never gets past that. I have 3 of the aforementioned servers, and when I netinstall centos on them, the installer recognizes the raid configuration and the logical disks and installs fine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |